Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM D4506-02(2006)
Standard Test Method for Determining the In Situ Modulus of Deformation of Rock Mass Using a Radial Jacking Test
Standard Test Method for Determining the In Situ Modulus of Deformation of Rock Mass Using a Radial Jacking Test
D4506-02R06
ASTM|D4506-02R06|en-US
Standard Test Method for Determining the In Situ Modulus of Deformation of Rock Mass Using a Radial Jacking Test
Standard
D4506 Standard Test Method for Determining the In Situ Modulus of Deformation of Rock Mass Using a Radial Jacking Test>
new
BOS Vol. 04.08 Committee D18
$
86.00
In stock
Significance and Use
Using this test method, a volume of rock large enough to take into account the influence of discontinuities on the properties of the rock mass is loaded. The test should be used when values are required which represent the true rock mass properties more closely than can be obtained through less expensive uniaxial jacking tests or other procedures.
Note 1—The quality of the result produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. Agencies that meet the criteria of Practice D 3740
Scope
1.1 This test method is used to determine the in situ modulus of deformation of rock mass by subjecting a test chamber of circular cross section to uniformly distributed radial loading; the consequent rock displacements are measured, from which elastic or deformation moduli may be calculated. The anisotropic deformability of the rock can also be measured and information on time-dependent deformation may be obtained.
1.2 This test method is based upon the procedures developed by the U.S. Bureau of Reclamation featuring long extensometers
1.3 Application of the test results is beyond the scope of this test method, but may be an integral part of some testing programs.
1.4 The values stated in inch-pound units are to be regarded as the standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.