Standard
Active
Last Updated: Sep 12, 2024
Track Document
ASTM D4164-24
Standard Test Method for Mechanically Tapped Packing Density of Formed Catalyst and Catalyst Carriers
Standard Test Method for Mechanically Tapped Packing Density of Formed Catalyst and Catalyst Carriers
D4164-24
ASTM|D4164-24|en-US
Standard Test Method for Mechanically Tapped Packing Density of Formed Catalyst and Catalyst Carriers
Standard
D4164 Standard Test Method for Mechanically Tapped Packing Density of Formed Catalyst and Catalyst Carriers>
new
BOS Vol. 05.06 Committee D32
$
64.00
In stock
ASTM International
Significance and Use
5.1 This test method is to be used for measuring the mechanically tapped packing density of formed particles that will not break up during sampling, filling, or tapping of the measuring cylinder under test conditions.
Scope
1.1 This test method covers the determination of the mechanically tapped density of formed catalyst and catalyst carriers. For the purpose of this test method, catalyst particles are defined as extrudates, spheres, or formed pellets of 0.8 mm to 4.8 mm (1/32 in. to 3/16 in.) nominal diameter.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.