Standard
Historical
Last Updated: Nov 09, 2015
Track Document
ASTM D4039-09
Standard Test Method for Reflection Haze of High-Gloss Surfaces
Standard Test Method for Reflection Haze of High-Gloss Surfaces
D4039-09
ASTM|D4039-09|en-US
Standard Test Method for Reflection Haze of High-Gloss Surfaces
Standard
D4039 Standard Test Method for Reflection Haze of High-Gloss Surfaces>
new
BOS Vol. 06.01 Committee E12
$
77.00
In stock
Significance and Use
Measured gloss values of specimens depend on the angle of illumination, refractive index of the material, and the geometric distribution of the reflected light.
Haze is produced by irregularities in the reflecting surface that affect the distribution of flux reflected around the specular angle. The procedures specified in Test Method D 523
In this test method, values for reflection haze are obtained from two measurements of specular gloss, one made with a large receptor aperture and the other made with a small receptor aperture. The geometric conditions have been chosen to permit the use of glossmeters that provide 60° specular gloss measurements (large receptor aperture) and 20° specular gloss measurements (small receptor aperture) as specified in Test Method D 523
An additional method for the measurement of reflection haze is given in Test Method E 430
Scope
1.1 This test method describes a procedure for using two specular gloss measurements to obtain a haze index for high-gloss nonmetallic specimens (1-4). It is particularly useful for evaluating the haze in clear finishes on nonglossy substrates, and the haze in reflected images produced by the surfaces of opaque glossy pigmented finishes.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.