Standard
Active
Last Updated: Jan 26, 2026
Track Document
ASTM D3612-02(2026)
Standard Test Method for Analysis of Gases Dissolved in Electrical Insulating Oil by Gas Chromatography
Standard Test Method for Analysis of Gases Dissolved in Electrical Insulating Oil by Gas Chromatography
D3612-02R26
ASTM|D3612-02R26|en-US
Standard Test Method for Analysis of Gases Dissolved in Electrical Insulating Oil by Gas Chromatography
Standard
D3612 Standard Test Method for Analysis of Gases Dissolved in Electrical Insulating Oil by Gas Chromatography>
new
BOS Vol. 10.03 Committee D27
$
104.00
In stock
ASTM International
Significance and Use
5.1 Oil and oil-immersed electrical insulation materials may decompose under the influence of thermal and electrical stresses, and in doing so, generate gaseous decomposition products of varying composition which dissolve in the oil. The nature and amount of the individual component gases that may be recovered and analyzed may be indicative of the type and degree of the abnormality responsible for the gas generation. The rate of gas generation and changes in concentration of specific gases over time are also used to evaluate the condition of the electric apparatus.
Note 1: Guidelines for the interpretation of gas-in-oil data are given in IEEE C57.104.
Scope
1.1 This test method covers three procedures for extraction and measurement of gases dissolved in electrical insulating oil having a viscosity of 20 cSt (100 SUS) or less at 40 °C (104 °F), and the identification and determination of the individual component gases extracted. Other methods have been used to perform this analysis.
1.2 The individual component gases that may be identified and determined include:
|
| Hydrogen—H2 |
|
| Oxygen—O2 |
|
| Nitrogen—N2 |
|
| Carbon monoxide—CO |
|
| Carbon dioxide—CO2 |
|
| Methane—CH4 |
|
| Ethane—C2H6 |
|
| Ethylene—C2H4 |
|
| Acetylene—C2H2 |
|
| Propane—C3H8 |
|
| Propylene—C3H6 |
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statements see 6.1.8, 30.2.2 and 30.3.1.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.