There is no PDF download available at this time. Please contact customer service.
Standard
Withdrawn, No replacement
Last Updated: Oct 17, 2022
Track Document
ASTM D3348-12(2017)
Standard Test Method for Rapid Field Test for Trace Lead in Unleaded Gasoline (Colorimetric Method) (Withdrawn 2022)
Standard Test Method for Rapid Field Test for Trace Lead in Unleaded Gasoline (Colorimetric Method) (Withdrawn 2022)
D3348-12R17
ASTM|D3348-12R17|en-US
Standard Test Method for Rapid Field Test for Trace Lead in Unleaded Gasoline (Colorimetric Method) (Withdrawn 2022)
Standard
D3348 Standard Test Method for Rapid Field Test for Trace Lead in Unleaded Gasoline (Colorimetric Method) (Withdrawn 2022)>
new
BOS Vol. 05.01 Committee D02
$
0.00
Out of stock
Significance and Use
4.1 This test is used to determine trace quantities of lead in unleaded gasoline. Unwarranted amounts of lead may cause deposits in automotive pollution control equipment and poisoning of catalytic mufflers.
Scope
1.1 This test method covers and is intended for use in the field by nontechnical people for the quantitative measurement of lead in unleaded gasoline in the range from 0.01 g to 0.10 g Pb/U.S. gal (2.64 mg to 26.4 mg Pb/L). This method applies to all commercial gasolines and responds to all types of lead alkyls as well as to other organic and inorganic forms of lead.
Note 1: This test method is based on the use of the Mobil Lead Test Kit (Fig. 1).
Note 2: This test method is a screening test and is not to be used as a replacement for withdrawn Test Method D3116, withdrawn Test Method D3229, Test Method D3237, Test Method D3341, or Test Method D5059.
FIG. 1 Mobil Lead Test Kit
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see Section 7.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.