Standard
Active
Last Updated: Jan 23, 2026
Track Document
ASTM D3087-26
Standard Test Method for Operating Performance of Anion-Exchange Materials for Strong Acid Removal
Standard Test Method for Operating Performance of Anion-Exchange Materials for Strong Acid Removal
D3087-26
ASTM|D3087-26|en-US
Standard Test Method for Operating Performance of Anion-Exchange Materials for Strong Acid Removal
Standard
D3087 Standard Test Method for Operating Performance of Anion-Exchange Materials for Strong Acid Removal>
new
BOS Vol. 11.02 Committee D19
$
64.00
In stock
ASTM International
Significance and Use
5.1 This test method can be used for evaluating performance of commercially available anion-exchange materials regardless of the basic strength of the ion exchange groups. When previous operating history is known, a good interpretation of resin fouling or malfunction can be obtained by comparison against a reference sample of unused ion-exchange material evaluated in the same way.
5.2 While resistivity has been chosen as the preferred analytical method for defining the exhaustion end point, with titration as the alternative, it is understood that observation of pH during rinse and the service run can yield useful information. The variations in pH observed with an ion exchange material suspected of having degraded, can be helpful in interpretation of performance when compared with similar data for a reference sample of unused material exhausted in the same way.
Scope
1.1 This test method covers the determination of the operating capacity of anion-exchange materials when used for the removal of hydrochloric and sulfuric acid from water. It is designed to simulate operating conditions for strong acid removal and is intended for use in testing both new and used materials.
1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.