Standard
Historical
Last Updated: May 03, 2024
Track Document
ASTM D3019/D3019M-17
Standard Specification for Lap Cement Used with Asphalt Roll Roofing, Non-Fibered, and Fibered
Standard Specification for Lap Cement Used with Asphalt Roll Roofing, Non-Fibered, and Fibered
D3019_D3019M-17
ASTM|D3019_D3019M-17|en-US
Standard Specification for Lap Cement Used with Asphalt Roll Roofing, Non-Fibered, and Fibered
Standard
D3019/D3019M Standard Specification for Lap Cement Used with Asphalt Roll Roofing, Non-Fibered, and Fibered>
new
BOS Vol. 04.04 Committee D08
$
77.00
In stock
ASTM International
Abstract
This specification covers the physical requirements and testing of three types of lap cement for use with asphalt roll roofing. Type I is a brushing consistency lap cement intended for use in the exposed-nailing method of roll roofing application, and contains no mineral or other stabilizers. This type is further divided into two grades, as follows: Grade 1, which is made with an air-blown asphalt; and Grade 2, which is made with a vacuum-reduced or steam-refined asphalt. Both Types II and III, on the other hand, are heavy brushing or light troweling consistency lap cement intended for use in the concealed-nailing method of roll roofing application, only that Type II cement contains a quantity of short-fibered asbestos, while Type III cement contains a quantity of mineral or other stabilizers, or both, but contains no asbestos. The lap cements shall be sampled for testing, and shall adhere to specified values of the following properties: water content; distillation (total distillate at given temperatures); softening point of residue; solubility in trichloroethylene; and strength at indicated age.
Scope
1.1 This specification covers lap cement consisting of asphalt dissolved in a volatile petroleum solvent with or without mineral or other stabilizers, or both, for use with roll roofing. The fibered version of these cements excludes the use of asbestos fibers.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 The following precautionary caveat applies only to the test method portion, Section 5, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.