Standard
Historical
Last Updated: Jan 01, 2024
Track Document
ASTM D2972-15
Standard Test Methods for Arsenic in Water
Standard Test Methods for Arsenic in Water
D2972-15
ASTM|D2972-15|en-US
Standard Test Methods for Arsenic in Water
Standard
D2972 Standard Test Methods for Arsenic in Water>
new
BOS Vol. 11.01 Committee D19
$
96.00
In stock
ASTM International
Significance and Use
4.1 Herbicides, insecticides, and many industrial effluents contain arsenic and are potential sources of water pollution. Arsenic is significant because of its adverse physiological effects on humans.
Scope
1.1 These test methods2 cover the photometric and atomic absorption determination of arsenic in most waters and wastewaters. Three test methods are given as follows:
|
| Concentration | Sections |
| Test Method A—Silver Diethyldithio- | 5 to 250 μg/L | 7 to 16 |
| Test Method B—Atomic Absorption, | 1 to 20 μg/L | 17 to 26 |
| Test Method C—Atomic Absorption, | 5 to 100 μg/L | 27 to 36 |
1.2 The analyst should direct attention to the precision and bias statements for each test method. It is the user's responsibility to ensure the validity of these test methods for waters of untested matrices.
1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 11.1 and 20.2.