Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM D2887-06a
Standard Test Method for Boiling Range Distribution of Petroleum Fractions by Gas Chromatography
Standard Test Method for Boiling Range Distribution of Petroleum Fractions by Gas Chromatography
D2887-06A
ASTM|D2887-06A|en-US
Standard Test Method for Boiling Range Distribution of Petroleum Fractions by Gas Chromatography
Standard
D2887 Standard Test Method for Boiling Range Distribution of Petroleum Fractions by Gas Chromatography>
new
BOS Vol. 05.01 Committee D02
$
96.00
In stock
Significance and Use
The boiling range distribution of petroleum fractions provides an insight into the composition of feedstocks and products related to petroleum refining processes. The gas chromatographic simulation of this determination can be used to replace conventional distillation methods for control of refining operations. This test method can be used for product specification testing with the mutual agreement of interested parties.
Boiling range distributions obtained by this test method are essentially equivalent to those obtained by true boiling point (TBP) distillation (see Test Method D 2892
Scope
1.1 This test method covers the determination of the boiling range distribution of petroleum products. The test method is applicable to petroleum products and fractions having a final boiling point of 538°C (1000°F) or lower at atmospheric pressure as measured by this test method. This test method is limited to samples having a boiling range greater than 55°C (100°F), and having a vapor pressure sufficiently low to permit sampling at ambient temperature.
1.2 This test method is not to be used for the analysis of gasoline samples or gasoline components. These types of samples must be analyzed by Test Method D 3710.
1.3 The values stated in SI units are to be regarded as standard. The inch-pound units given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.