Standard
Active
Last Updated: Jun 24, 2024
Track Document
ASTM D2574-16(2024)
Standard Test Method for Resistance of Emulsion Paints in the Container to Attack by Microorganisms
Standard Test Method for Resistance of Emulsion Paints in the Container to Attack by Microorganisms
D2574-16R24
ASTM|D2574-16R24|en-US
Standard Test Method for Resistance of Emulsion Paints in the Container to Attack by Microorganisms
Standard
D2574 Standard Test Method for Resistance of Emulsion Paints in the Container to Attack by Microorganisms>
new
BOS Vol. 06.01 Committee D01
$
64.00
In stock
ASTM International
Significance and Use
4.1 Spoilage of paint in the container can result in putrefaction, lowered pH, gas formation, and decrease in viscosity. This test method provides a standard procedure for the evaluation of the resistance of emulsion paints to microbial deterioration. The results should enable: (1) the paint manufacturer to select an effective preservative and (2) the supplier of preservatives to evaluate the performance in emulsion paints of competitive and developmental preservatives.
4.2 This test method should be used preferably by persons who have had basic microbiological training.
Note 1: The reliability of the results obtained from this test method is extremely dependent on the techniques employed. Improper techniques can result in a sterile sample appearing to be contaminated, and even worse, a contaminated sample appearing to be sterile (see also Note 2). It is recommended that you consult with your biocide supplier, raw material supplier, or an independent testing laboratory to confirm questionable results. Formulation and raw materials’ quality may also vary and thereby affect the test results.
Scope
1.1 This test method covers the determination of the relative resistance of emulsion paints to attack in the container by microorganisms.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.