Standard
Historical
Last Updated: Jan 09, 2012
Track Document
ASTM D2556-93a(2005)
Standard Test Method for Apparent Viscosity of Adhesives Having Shear-Rate-Dependent Flow Properties
Standard Test Method for Apparent Viscosity of Adhesives Having Shear-Rate-Dependent Flow Properties
D2556-93AR05
ASTM|D2556-93AR05|en-US
Standard Test Method for Apparent Viscosity of Adhesives Having Shear-Rate-Dependent Flow Properties
Standard
D2556 Standard Test Method for Apparent Viscosity of Adhesives Having Shear-Rate-Dependent Flow Properties>
new
BOS Vol. 15.06 Committee D14
$
77.00
In stock
Significance and Use
The principle of measurement is based upon a reversible isothermal change in apparent viscosity with change in rate of shear.
Measurement is performed with a spindle, disk, T-bar, or coaxial cylinder rotational viscometer under standardized conditions with rigid control of the time intervals of measurement. Readings are obtained on the viscometer dial scale at the end of 1 min for each rotational speed. Changes from the lowest speed to the highest speed, and return to the lowest speed, are made without stopping the instrument.
Scope
1.1 This test method covers the measurement of the apparent viscosity of shear-rate-dependent adhesives.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.