Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM D2521-76(2002)e1
Standard Specification for Asphalt Used in Canal, Ditch, and Pond Lining
Standard Specification for Asphalt Used in Canal, Ditch, and Pond Lining
D2521-76R02E01
ASTM|D2521-76R02E01|en-US
Standard Specification for Asphalt Used in Canal, Ditch, and Pond Lining
Standard
D2521 Standard Specification for Asphalt Used in Canal, Ditch, and Pond Lining>
new
BOS Vol. 04.04 Committee D08
$
77.00
In stock
Abstract
This specification covers the sampling, testing, and physical requirements of oxidized petroleum asphalt, which when applied in a sufficient thickness over a suitable subgrade and covered with a suitable cover material, will provide a satisfactory waterproof membrane for use as a canal, ditch, and pond lining. The asphalt shall not foam when heated are a specified temperature, when tested using appropriate methods, shall conform accordingly to the following properties: softening point (ring and ball); penetration points; ductility; flash point (Cleveland open cup); solubility in trichloroethylene; and loss in heating.
Scope
1.1 This specification covers an oxidized petroleum asphalt, which, when applied in a sufficient thickness over a suitable subgrade and covered with a suitable cover material, will provide a satisfactory waterproof membrane for use as a canal, ditch, and pond lining.
1.2 The values in SI units are to be regarded as standard. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.