Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM D2168-02a
Standard Test Methods for Calibration of Laboratory Mechanical-Rammer Soil Compactors
Standard Test Methods for Calibration of Laboratory Mechanical-Rammer Soil Compactors
D2168-02A
ASTM|D2168-02A|en-US
Standard Test Methods for Calibration of Laboratory Mechanical-Rammer Soil Compactors
Standard
D2168 Standard Test Methods for Calibration of Laboratory Mechanical-Rammer Soil Compactors>
new
BOS Vol. 04.08 Committee D18
$
86.00
In stock
Significance and Use
Mechanical compactors are commonly used to replace the hand compactors required for Test Methods D 698
The design of mechanical compactors is such that it is necessary to have a calibration process that goes beyond determining the mass and drop of the hammer.
Note 1—The quality of the result produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. Agencies that meet the criteria is Practice D 3740
Scope
1.1 These test methods for the calibration of mechanical soil compactors are for use in checking and adjusting mechanical devices used in laboratory compacting of soil and soil-aggregate in accordance with Test Methods D 698, D 1557 and other methods of a similar nature which might specify this method. Calibration for use with one method does not qualify the equipment for use with another method.
1.2 The weight of the mechanical rammer is adjusted as described in and in order to provide that the mechanical compactor will produce the same result as the manual compactor.
1.3 Two alternative procedures are provided as follows:
| Section | ||
| Test Method A | Calibration based on the compaction of a selected soil sample | 5 |
| Test Method B | Calibration based on the deformation of a standard lead cylinder | 6 |
1.4 If a mechanical compactor is calibrated in accordance with the requirements of either Test Method A or Test Method B, it is not necessary for it to meet the requirements of the other method.
1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.