Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM D1895-96(2003)
Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials
Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials
D1895-96R03
ASTM|D1895-96R03|en-US
Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials
Standard
D1895 Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials>
new
BOS Vol. 08.01 Committee D20
$
86.00
In stock
Significance and Use
These test methods provide useful indexes of performance of plastic materials such as powders and granules with respect to their handling in packaging and fabrication.
Apparent density is a measure of the fluffiness of a material.
Bulk factor is a measure of volume change that may be expected in fabrication.
Pourability characterizes the handling properties of a finely divided plastic material. It is a measure of the readiness with which such materials will flow through hoppers and feed tubes and deliver uniform weights of material.
Scope
1.1 These test methods cover the measurement of apparent density, bulk factor, and where applicable, the pourability of plastic materials such as molding powders. Different procedures are given for application to the various forms of these materials that are commonly encountered, from fine powders and granules to large flakes and cut fibers.
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1—Test Method A is equivalent to ISO Method R 60 as described in the appendix. Test Method C is identical with ISO Method R 61.