Standard
Historical
Last Updated: Dec 22, 2025
Track Document
ASTM D1826-94(2025)e1
Standard Test Method for Calorific (Heating) Value of Gases in Natural Gas Range by Continuous Recording Calorimeter
Standard Test Method for Calorific (Heating) Value of Gases in Natural Gas Range by Continuous Recording Calorimeter
D1826-94R25E01
ASTM|D1826-94R25E01|en-US
Standard Test Method for Calorific (Heating) Value of Gases in Natural Gas Range by Continuous Recording Calorimeter
Standard
D1826 Standard Test Method for Calorific (Heating) Value of Gases in Natural Gas Range by Continuous Recording Calorimeter>
new
BOS Vol. 05.06 Committee D03
$
72.00
In stock
ASTM International
Significance and Use
4.1 This test method provides an accurate and reliable method to measure the total calorific value of a fuel gas, on a continuous basis, which is used for regulatory compliance, custody transfer, and process control.
Scope
1.1 This test method covers the determination with the continuous recording calorimeter (Note 1) of the total calorific (heating) value of fuel gas produced or sold in the natural gas range from 900 to 1200 Btu/standard ft3.
Note 1: An extensive investigation of the accuracy of the Cutler-Hammer recording gas calorimeter, when used with gases of high heating value, was made by the National Bureau of Standards in 1957 under a research project sponsored by the American Gas Association.
1.2 The subjects covered in this test method appear in the following sections:
|
| Sections | |
| Air-Gas Ratio Test | 11 | |
| Apparatus | 5 | |
| Basis of Measurement | 14 | |
| Cold Balance Test | 10 | |
| Compensation of Complicating Factors | 13 | |
| Condition of Gas Sample | 7 | |
| Definitions | 2 | |
| Installation of Apparatus | 6 | |
| Maintenance | Appendix X1 | |
| Operating Precautions | Appendix X2 | |
| Operation and Checking of Apparatus | 9 | |
| Precision | 15 | |
| Scope | 1 | |
| Significance and Use | 4 | |
| Standardization of Calorimeter | 12 | |
| Standardization, Preliminary, of Calorimeter by Hydrogen | 8 | |
| Summary of Test Method | 3 | |
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.