Standard
Historical
Last Updated: Jun 30, 2017
Track Document
ASTM D1691-12
Standard Test Methods for Zinc in Water
Standard Test Methods for Zinc in Water
D1691-12
ASTM|D1691-12|en-US
Standard Test Methods for Zinc in Water
Standard
D1691 Standard Test Methods for Zinc in Water>
new
BOS Vol. 11.01 Committee D19
$
86.00
In stock
Significance and Use
4.1 Zinc is an essential and beneficial element in body growth. Concentrations above 5 mg/L can cause a bitter astringent taste and opalescence in alkaline waters. The zinc concentration of U.S. drinking waters varies between 0.06 and 7.0 mg/L with a mean of 1.33 mg/L. Zinc most commonly enters the domestic water supply from deterioration of galvanized iron and dezincification of brass. Zinc in water also may result from industrial water pollution.3
Scope
1.1 These test methods cover the determination of zinc in water. Two test methods are given as follows:
| Test Method | Concentration Range | Sections |
| A—Atomic Absorption, Direct | 0.05 to 2 mg/L | |
| B—Atomic Absorption, | 20 to 200 μg/L |
1.3 These test methods have been used successfully with reagent grade water. See the specific test method for applicability to other matrices. It is the user's responsibility to assure the validity of these test methods in other matrices.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are mathematical conversions and may not be exact equivalents; therefore, each system shall be used independently of the other.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 6 and Note 6, Note 10, and Note 16.
1.6 Two former colorimetric test methods were discontinued. Refer to Appendix X1 for historical information.