Standard
Historical
Last Updated: May 10, 2024
Track Document
ASTM D1662-19
Standard Test Method for Active Sulfur in Cutting Oils
Standard Test Method for Active Sulfur in Cutting Oils
D1662-19
ASTM|D1662-19|en-US
Standard Test Method for Active Sulfur in Cutting Oils
Standard
D1662 Standard Test Method for Active Sulfur in Cutting Oils>
new
BOS Vol. 05.01 Committee D02
$
77.00
In stock
ASTM International
Significance and Use
5.1 This test method measures the quantity of sulfur available to react with metallic surfaces to form solid lubricating aids at the temperature of the test. Rates of reaction are metal type, temperature, and time dependent.
Scope
1.1 This test method covers the determination of active sulfur in cutting oils. This test method applies to sulfur reactive with copper powder at a temperature of 150 °C (302 °F) in cutting fluids containing both natural and added sulfur.
Note 1: It has not been established by ASTM Subcommittee D02.L0 as to how the active sulfur content thus determined may relate to field performance of the cutting fluid.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.