Standard
Historical
Last Updated: Dec 12, 2024
Track Document
ASTM D1611-12(2019)
Standard Test Method for Corrosion Produced by Leather in Contact with Metal
Standard Test Method for Corrosion Produced by Leather in Contact with Metal
D1611-12R19
ASTM|D1611-12R19|en-US
Standard Test Method for Corrosion Produced by Leather in Contact with Metal
Standard
D1611 Standard Test Method for Corrosion Produced by Leather in Contact with Metal>
new
BOS Vol. 15.04 Committee D31
$
77.00
In stock
ASTM International
Significance and Use
5.1 The procedure is primarily intended to evaluate chrome leather intended for use in hydraulic systems under circumstances where metal corrosion is a serious factor. A high relative humidity is used for the purpose of accelerating the results.
Scope
1.1 This test method covers the qualitative and quantitative determination of corrosion produced by leather in contact with metal. This test method does not apply to wet blue.
1.2 The values stated in inch-pound units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.