Standard
Active
Last Updated: Dec 12, 2025
Track Document
ASTM D1245-17(2025)
Standard Practice for Examination of Water-Formed Deposits by Chemical Microscopy
Standard Practice for Examination of Water-Formed Deposits by Chemical Microscopy
D1245-17R25
ASTM|D1245-17R25|en-US
Standard Practice for Examination of Water-Formed Deposits by Chemical Microscopy
Standard
D1245 Standard Practice for Examination of Water-Formed Deposits by Chemical Microscopy>
new
BOS Vol. 11.02 Committee D19
$
72.00
In stock
ASTM International
Significance and Use
5.1 Chemical composition of water-formed deposits is a major indicator of proper or improper chemical treatment of process water, and is often an indicator of operational parameters as well, for example, temperature control. This practice allows for rapid determination of constituents present in these deposits, particularly those indications of improper water treatment, since they usually have very distinctive and easily recognized optical properties.
5.2 This practice, where applicable, eliminates the need for detailed chemical analysis, which is time-consuming, and which does not always reveal how cations and anions are mutually bound.
5.3 Qualitative use of this practice should be limited to those deposits whose control is generally known or predictable, based on treatment and feedwater mineral content, and whose constituents are crystalline, or in other ways optically or morphologically distinctive. If these criteria are not met, other techniques of analysis should be used, such as Practice D2332 or Test Methods D3483, or both.
5.4 Quantitative use of this practice should be limited to estimates only. For more precise quantitative results, other methods should be used (see 5.3).
Scope
1.1 This practice describes a procedure for the examination of water-formed deposits by means of chemical microscopy. This practice may be used to complement other methods of examination of water-formed deposits as recommended in Practices D2331 or it may be used alone when no other instrumentation is available or when the sample size is very small.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.