Standard
Historical
Last Updated: Jun 30, 2016
Track Document
ASTM D1084-08
Standard Test Methods for Viscosity of Adhesives
Standard Test Methods for Viscosity of Adhesives
D1084-08
ASTM|D1084-08|en-US
Standard Test Methods for Viscosity of Adhesives
Standard
D1084 Standard Test Methods for Viscosity of Adhesives>
new
BOS Vol. 15.06 Committee D14
$
86.00
In stock
Significance and Use
Several test methods are noted for viscosity determination of Newtonian and near Newtonian flow characteristics. (For adhesives not fitting into this category, Test Method D 2556
Method A is applicable only to adhesives that will deliver 50 mL in a steady uninterrupted stream from one of the cups described in Section 5.
Method B is intended for measuring the viscosity of adhesives covering a range from 0.05 Pa · s to 200 Pa · s
(50 to 200 000 cP) and is limited to materials that have or approach Newtonian flow characteristics.
Method C is intended primarily as a control method for determining the viscosity of adhesives that have or approach Newtonian flow characteristics.
Method D is intended primarily as a control method for determining the viscosity of materials that have an equivalent viscosity no greater than approximately 3000 cP and is limited to materials that have or approach Newtonian flow characteristics.
Scope
1.1 These test methods cover the determination of the viscosity of free-flowing adhesives.
1.1.1 The limitation of this test method to self-leveling adhesives eliminates thixotropic and plastic materials whose viscosity is a function of the rate of stirring and previous history of the adhesive.
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.