Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM D624-00e1
Standard Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers
Standard Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers
D0624-00E01
ASTM|D0624-00E01|en-US
Standard Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers
Standard
D624 Standard Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers>
new
BOS Vol. 09.01 Committee D11
$
86.00
In stock
Significance and Use
Vulcanized rubber and thermoplastic elastomers (TPE) often fail in service due to the generation and propagation of a special type of rupture called a tear. This test method measures the resistance to tearing action.
Tear strength may be influenced to a large degree by stress-induced anisotropy (mechanical fibering), stress distribution, strain rate, and test piece size. The results obtained in a tear strength test can only be regarded as a measure under the conditions of that particular test and may not have any direct relation to service performance. The significance of tear testing must be determined on an individual application or product performance basis.
Scope
1.1 This test method describes procedures for measuring a property of conventional vulcanized thermoset rubber and thermoplastic elastomers called tear strength.
1.2 The values stated in S1 units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.