Standard
Active
Last Updated: Jan 19, 2022
Track Document
ASTM C1918-21
Standard Test Method for Water Retention of Rigid Thermal Insulation Materials after Immersion and Exposure to Drying Conditions
Standard Test Method for Water Retention of Rigid Thermal Insulation Materials after Immersion and Exposure to Drying Conditions
C1918-21
ASTM|C1918-21|en-US
Standard Test Method for Water Retention of Rigid Thermal Insulation Materials after Immersion and Exposure to Drying Conditions
Standard
C1918 Standard Test Method for Water Retention of Rigid Thermal Insulation Materials after Immersion and Exposure to Drying Conditions>
new
BOS Vol. 04.06 Committee C16
$
64.00
In stock
ASTM International
Significance and Use
5.1 This test method provides a means of measuring the water retention of flat specimens of rigid thermal insulation as a result of immersion in water and exposure to drying conditions.
Scope
1.1 This test method determines the amount of water retained (excluding surface water) by flat specimens of rigid thermal insulations after immersion and exposure to drying conditions. This test method is intended to be used for the characterization of materials in the laboratory. It is not intended to simulate any particular environmental condition potentially encountered in building construction applications.
1.2 This test method does not address all the possible mechanisms of water intake and retention and related phenomena for rigid thermal insulations. It relates only to those conditions outlined in 1.1. Determination of moisture accumulation in thermal insulations due to partial immersion, water vapor transmission, internal condensation, freeze-thaw cycling, or a combination of these effects requires different test procedures.
1.3 This test method does not address or attempt to quantify the drainage characteristics of materials.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems has the potential to result in non-conformance with the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.