Standard
Historical
Last Updated: Feb 15, 2021
Track Document
ASTM C1770-13
Standard Test Method for Determination of Loose and Tapped Bulk Density of Plutonium Oxide
Standard Test Method for Determination of Loose and Tapped Bulk Density of Plutonium Oxide
C1770-13
ASTM|C1770-13|en-US
Standard Test Method for Determination of Loose and Tapped Bulk Density of Plutonium Oxide
Standard
C1770 Standard Test Method for Determination of Loose and Tapped Bulk Density of Plutonium Oxide>
new
BOS Vol. 12.01 Committee C26
$
77.00
In stock
Significance and Use
5.1 This test method is intended for determination of bulk loose or tapped density or both for plutonium oxide or similar metallic powders or compounds in the nuclear industry. It is intended for use when the quantity of available material for performing the measurements is limited because of reasons such as nuclear safety or laboratory scale limits on nuclear inventory.
5.2 Values of loose bulk density obtained using this test method should be used with caution since they can vary considerably depending on the initial state of dispersion of the test specimen, height-to-diameter ratio of the specimen in the graduated cylinder, the dryness of the powder, and other factors.
5.3 The data from the tapped bulk density test can be used to estimate the needed volume of small containers holding a fixed mass of powder that has been compacted.
5.4 This test method may be useful for the determination of the Carr Compressibility Index as described in Test Method D6393.
Scope
1.1 This test method specifies a method for the determination of loose and tapped bulk density of plutonium oxide powder.
1.2 This test method is applicable when limited quantities of powder are available for performance of the measurements. Alternative test methods, such as Test Methods B527 or D7481, may be used when sufficient quantities are available.
1.3 This test method contains notes that are explanatory and are not part of the mandatory requirements of the method.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Some specific hazards statements are given in Section 7 on Hazards.