Standard
Active
Last Updated: Jul 07, 2023
Track Document
ASTM C1681-23
Standard Test Method for Evaluating the Tear Resistance of a Sealant Under Constant Strain
Standard Test Method for Evaluating the Tear Resistance of a Sealant Under Constant Strain
C1681-23
ASTM|C1681-23|en-US
Standard Test Method for Evaluating the Tear Resistance of a Sealant Under Constant Strain
Standard
C1681 Standard Test Method for Evaluating the Tear Resistance of a Sealant Under Constant Strain>
new
BOS Vol. 04.07 Committee C24
$
72.00
In stock
ASTM International
Significance and Use
5.1 This test method is intended to determine if a joint that is subjected to a mechanically induced cut will resist tear propagation during normal joint movement.
Note 1: A sealant with a high resistance to tear propagation may perform better than a sealant with a low resistance to tear propagation.
Scope
1.1 This test method evaluates the impact of an induced tear on a sealant specimen that is dimensioned, cured according to the guidelines in Test Method C719 and then subjected to a constant strain. It is effective in differentiating between sealants that are used in dynamic joints subject to abrasion, punctures, tears, or combination thereof.
1.2 Since this test method is for the evaluation of tear propagation, an adhesive failure to the substrates provides no usable data regarding tear propagation. This would be considered a failed test and that data would be discarded, or at least separated from the other data from specimens that did not experience an adhesive failure.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This standard is similar in concept to European Technical Approval Guidelines (ETAG) 002, Part 1, Section 5.1.4.6.4—Resistance To Tearing.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.