Standard
Historical
Last Updated: Jan 30, 2013
Track Document
ASTM C1403-06
Standard Test Method for Rate of Water Absorption of Masonry Mortars
Standard Test Method for Rate of Water Absorption of Masonry Mortars
C1403-06
ASTM|C1403-06|en-US
Standard Test Method for Rate of Water Absorption of Masonry Mortars
Standard
C1403 Standard Test Method for Rate of Water Absorption of Masonry Mortars>
new
BOS Vol. 04.05 Committee C12
$
77.00
In stock
Significance and Use
This test method provides a laboratory procedure for determining the relative water absorption properties over time of mortars used for masonry construction. Because the specimens are made under laboratory conditions and do not take into account the effect of the masonry substrate or field mixing procedures, this method is not intended for field use. Data generated from this test method may be useful for determining the relative effectiveness of water repellent admixtures or the effect of other admixtures or mortar components on the water repellency of a mortar. However, use caution in interpreting the results. While the resistance of masonry to water penetration may be related to the water absorption of the mortar, it also depends on other factors, such as the workmanship, extent of bond, and the properties of the masonry units and mortar.
Scope
1.1 This test method covers a standardized laboratory procedure for determining the relative water absorption by capillary uptake (wicking) characteristics of masonry mortars. This test method is not applicable for determining the effectiveness of water repellent coatings.
1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.