Standard
Historical
Last Updated: Mar 23, 2023
Track Document
ASTM C1381/C1381M-97(2018)
Standard Specification for Molded Glass Fiber Reinforced Gypsum Parts
Standard Specification for Molded Glass Fiber Reinforced Gypsum Parts
C1381_C1381M-97R18
ASTM|C1381_C1381M-97R18|en-US
Standard Specification for Molded Glass Fiber Reinforced Gypsum Parts
Standard
C1381/C1381M Standard Specification for Molded Glass Fiber Reinforced Gypsum Parts>
new
BOS Vol. 04.01 Committee C11
$
77.00
In stock
Abstract
This specification covers molded glass fiber reinforced gypsum (GRG) parts, which are nonload-bearing, thin-shell, ornamental shapes for architectural embellishment of interior building construction. GRG parts shall be produced using the same materials used to make the composites in conformance with the referenced specification. GRG parts shall be manufactured from the mixed slurry or alpha gypsum cement, potable water and additives, and glass fiber reinforcement using either the hand lay-up or the spray-up process in a mold. GRG parts shall be produced according to approved shop drawings. Shop drawings shall specify part dimensions, quantities, recommended attachment points and methods, reinforcements, embedments, and tolerance. The material shall conform to the required mechanical properties and to the specified dimensions and tolerances of GRG parts.
Scope
1.1 This specification covers molded glass fiber reinforced gypsum (GRG) parts, which are nonload-bearing, thin-shell, ornamental shapes for architectural embellishment of interior building construction.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 The information presented refers to the molded surface of the part.
1.4 The text of this standard references footnotes, which provide explanatory material. These footnotes shall not be considered as requirements of the standard.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.