Standard
Historical
Last Updated: Aug 16, 2017
Track Document
ASTM C1126-98
Standard Specification for Faced or Unfaced Rigid Cellular Phenolic Thermal Insulation
Standard Specification for Faced or Unfaced Rigid Cellular Phenolic Thermal Insulation
C1126-98
ASTM|C1126-98|en-US
Standard Specification for Faced or Unfaced Rigid Cellular Phenolic Thermal Insulation
Standard
C1126 Standard Specification for Faced or Unfaced Rigid Cellular Phenolic Thermal Insulation>
new
BOS Vol. 04.06 Committee C16
$
86.00
In stock
Scope
1.1 This specification applies to faced or unfaced, rigid cellular phenolic thermal insulation in either board or tubular form. It does not apply to field expanded cellular phenolic materials.
1.2 Materials covered by this specification are used as roof insulation; sheathing or rigid board for non-load bearing, building material applications; and pipe insulation for use between -40 and 257oF (-40 and 125oC). Type II Grade 1 and Type III Grade 1 materials with an appropriate vapor retarder covering on the warm surface can be used to a lower temperature limit of -290oF (-180oC). (See 7.2.)
1.3 The values stated in inch-pound units are to be regarded as standard. International Standard Units (SI) are given in parentheses.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 16 .