There is no PDF download available at this time. Please contact customer service.
Standard
Withdrawn, No replacement
Last Updated: Jan 06, 2022
Track Document
ASTM C1120/C1120M-98(2019)
Standard Test Method for Wash Test of Asbestos (Withdrawn 2022)
Standard Test Method for Wash Test of Asbestos (Withdrawn 2022)
C1120_C1120M-98R19
ASTM|C1120_C1120M-98R19|en-US
Standard Test Method for Wash Test of Asbestos (Withdrawn 2022)
Standard
C1120/C1120M Standard Test Method for Wash Test of Asbestos (Withdrawn 2022)>
new
BOS Vol. 04.05 Committee C17
$
0.00
Out of stock
Significance and Use
5.1 The wash test gives a rapid and simple evaluation of the fines content.
5.2 The equipment required and the technique followed are both simple and undemanding.
5.3 The fines content obtained by this test method approximates the equivalent screen classification obtained by Test Methods C1121 and D2589.
Scope
1.1 This test method covers the procedure for determining the fines content of asbestos fibers by washing with water on a specified sieve.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 Warning—Breathing of asbestos dust is hazardous. Asbestos and asbestos products present demonstrated health risks for users and for those with whom they come into contact. In addition to other precautions, when working with asbestos-cement products, minimize the dust that results. For information on the safe use of chrysoltile asbestos, refer to “Safe Use of Chrysotile Asbestos: A Manual on Preventive and Control Measures.”2
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For a specific hazards warning, see 1.3.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.