Standard
Historical
Last Updated: Jan 07, 2013
Track Document
ASTM C1064/C1064M-11
Standard Test Method for Temperature of Freshly Mixed Hydraulic-Cement Concrete
Standard Test Method for Temperature of Freshly Mixed Hydraulic-Cement Concrete
C1064_C1064M-11
ASTM|C1064_C1064M-11|en-US
Standard Test Method for Temperature of Freshly Mixed Hydraulic-Cement Concrete
Standard
C1064/C1064M Standard Test Method for Temperature of Freshly Mixed Hydraulic-Cement Concrete>
new
BOS Vol. 04.02 Committee C09
$
77.00
In stock
Significance and Use
This test method provides a means for measuring the temperature of freshly mixed concrete. The measured temperature represents the temperature at the time of testing and may not be an indication of the temperature of the freshly mixed concrete at a later time. It may be used to verify conformance to a specified requirement for temperature of concrete.
Concrete containing aggregate of a nominal maximum size greater than 75 mm [3 in.] may require up to 20 min for the transfer of heat from aggregate to mortar. (See ACI Committee 207.1R Report. )
Scope
1.1 This test method covers the determination of temperature of freshly mixed hydraulic-cement concrete.
1.2 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 The text of this standard references notes and footnotes that provide explanatory information. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (Warning