Standard
Historical
Last Updated: Jul 19, 2017
Track Document
ASTM C980-13a
Standard Specification for Industrial Chimney Lining Brick
Standard Specification for Industrial Chimney Lining Brick
C0980-13A
ASTM|C0980-13A|en-US
Standard Specification for Industrial Chimney Lining Brick
Standard
C980 Standard Specification for Industrial Chimney Lining Brick>
new
BOS Vol. 04.05 Committee C15
$
77.00
In stock
Abstract
This specification covers solid kiln fired brick made from clay, shale, or mixtures thereof suitable for use in masonry construction in contact with the chemicals present in flue gases found in industrial chimneys. These brick are normally used with chemical-resistant mortars. Chimney lining bricks are classified according to types: Types I, II, and III. The following test methods shall be performed for the materials to meet the specified requirements: sulfuric acid boil test: compressive strength test; water absorption; sizes; warpage; and texture.
Scope
1.1 This specification covers solid kiln fired brick made from clay, shale, or mixtures thereof suitable for use in masonry construction in contact with the chemicals present in flue gases found in industrial chimneys. These brick are normally used with chemical-resistant mortars.
1.2 Terminology related to industrial floor brick is found in Terminology C1232.
1.3 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.