Standard
Active
Last Updated: Jul 14, 2023
Track Document
ASTM C884/C884M-23
Standard Test Method for Thermal Compatibility Between Concrete and an Epoxy-Resin Overlay
Standard Test Method for Thermal Compatibility Between Concrete and an Epoxy-Resin Overlay
C0884_C0884M-23
ASTM|C0884_C0884M-23|en-US
Standard Test Method for Thermal Compatibility Between Concrete and an Epoxy-Resin Overlay
Standard
C884/C884M Standard Test Method for Thermal Compatibility Between Concrete and an Epoxy-Resin Overlay>
new
BOS Vol. 04.02 Committee C09
$
64.00
In stock
ASTM International
Significance and Use
5.1 This test method applies to materials used in making epoxy-mortar overlays for concrete pavement. If debonding occurs between the overlay and the pavement, the material is unsuitable.
5.2 This test method evaluates the ability of an overlay to remain bonded to a concrete substrate during repeated thermal cycling in air over a significant temperature range and is not intended to duplicate temperature fluctuations in the field.
Scope
1.1 This test method covers the determination of which epoxy-resin formulations are subject to debonding when used as overlays for concrete when the combination of the two is subjected to temperature changes that may be met in the field.
1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the specification.
1.3 The text of this standard refers to notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. A specific hazard statement is given in Section 8. (Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to exposed skin and tissue upon prolonged exposure.)2
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.