Standard
Active
Last Updated: Jun 06, 2025
Track Document
ASTM C787-20(2025)
Standard Specification for Uranium Hexafluoride for Enrichment
Standard Specification for Uranium Hexafluoride for Enrichment
C0787-20R25
ASTM|C0787-20R25|en-US
Standard Specification for Uranium Hexafluoride for Enrichment
Standard
C787 Standard Specification for Uranium Hexafluoride for Enrichment>
new
BOS Vol. 12.01 Committee C26
$
64.00
In stock
ASTM International
Abstract
This specification covers uranium hexafluoride intended for feeding to an enrichment plant. Plants preparing uranium hexafluoride will have to control the purity of process chemicals and also employ low corrosion equipment to be successful in meeting the specifications for most impurities. Chemical and isotopic analysis of the material shall conform to the requirements prescribed.
Scope
1.1 This specification covers uranium hexafluoride (UF6) intended for feeding to an enrichment plant. Included are specifications for UF6 derived from unirradiated natural uranium and UF6 derived from irradiated uranium that has been reprocessed and converted to UF6 for enrichment and subsequent reuse. The objectives of this specification are twofold: (1) to define the impurity and uranium isotope limits for Commercial Natural UF6 feedstock, and (2) to define additional limits for Reprocessed UF6 (or any mixture of Reprocessed UF6 and Commercial Natural UF6). For such UF6, special provisions may be needed to ensure that no extra hazard arises to the work force, process equipment, or the environment.
1.2 The scope of this specification does not comprehensively cover all provisions for preventing criticality accidents or requirements for health and safety or for shipping. Observance of this specification does not relieve the user of the obligation to conform to all international, federal, state, and local regulations for processing, shipping, or in any other way using UF6 (for example, see TID-7016, DP-532, ORNL-NUREG-CSD-6, and DOE O 474.1).
1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.