Standard
Active
Last Updated: Jan 08, 2024
Track Document
ASTM C615/C615M-23
Standard Specification for Granite Dimension Stone
Standard Specification for Granite Dimension Stone
C0615_C0615M-23
ASTM|C0615_C0615M-23|en-US
Standard Specification for Granite Dimension Stone
Standard
C615/C615M Standard Specification for Granite Dimension Stone>
new
BOS Vol. 04.07 Committee C18
$
64.00
In stock
ASTM International
Abstract
This specification covers the material characteristics, physical requirements, and sampling method appropriate to the selection of granite dimension stone for general building and structural purposes. Granite dimension stone shall include stone that is sawed, cut, split, or otherwise finished or shaped, and shall specifically exclude molded, cast, or otherwise artificially aggregated units composed of fragments, crushed and broken stone. Granite stones covered here shall be used for: exterior and interior cladding of buildings and structures; curbstone, paving, and landscape features; structural components having established dimensions; grade separations and retaining walls; and monuments. The physical property requirements to which granite stones shall adhere to are absorption by weight, density, compressive weight, modulus of rupture, abrasion resistance, and flexural strength.
Scope
1.1 This specification covers the material characteristics, physical requirements, and sampling appropriate to the selection of granite for general building and structural purposes. Refer to Guides C1242 and C1528 for the appropriate selection and use of granite dimension stone.
1.2 Granite dimension stone shall include stone that is sawed, cut, split, or otherwise finished or shaped, and shall specifically exclude molded, cast, or otherwise artificially aggregated units composed of fragments, crushed and broken stone.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.