Standard
Active
Last Updated: Dec 06, 2023
Track Document
ASTM C596-23
Standard Test Method for Drying Shrinkage of Mortar Containing Hydraulic Cement
Standard Test Method for Drying Shrinkage of Mortar Containing Hydraulic Cement
C0596-23
ASTM|C0596-23|en-US
Standard Test Method for Drying Shrinkage of Mortar Containing Hydraulic Cement
Standard
C596 Standard Test Method for Drying Shrinkage of Mortar Containing Hydraulic Cement>
new
BOS Vol. 04.01 Committee C01
$
64.00
In stock
ASTM International
Significance and Use
4.1 This test method establishes a selected set of conditions of temperature, relative humidity and rate of evaporation of the environment to which a mortar specimen of stated composition shall be subjected for a specified period of time during which its change in length is determined and designated “drying shrinkage.”
4.2 The drying shrinkage of mortar as determined by this test method has a linear relation to the drying shrinkage of concrete made with the same cement and exposed to the same drying conditions.4 Hence this test method may be used when it is desired to develop data on the effect of a hydraulic cement on the drying shrinkage of concrete made with that cement.
Scope
1.1 This test method determines the change in length on drying of mortar bars containing hydraulic cement and graded standard sand.
1.2 The values stated in SI units are to be regarded as standard. When combined standards are referenced, the selection of measurement system is at the user’s discretion subject to the requirements of the referenced standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure).2
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.