Standard
Active
Last Updated: Jul 07, 2022
Track Document
ASTM C141/C141M-14(2022)
Standard Specification for Hydrated Hydraulic Lime for Structural Purposes
Standard Specification for Hydrated Hydraulic Lime for Structural Purposes
C0141_C0141M-14R22
ASTM|C0141_C0141M-14R22|en-US
Standard Specification for Hydrated Hydraulic Lime for Structural Purposes
Standard
C141/C141M Standard Specification for Hydrated Hydraulic Lime for Structural Purposes>
new
BOS Vol. 04.01 Committee C07
$
64.00
In stock
Abstract
This specification covers hydraulic hydrated lime for structural purposes. Hydraulic hydrated lime may be used in the scratch or brown coat of plaster, stucco, mortar, or in Portland-cement concrete either as blend, amendment, or admixture. The hydraulic hydrated lime shall conform to the chemical composition requirements for calcium oxide, magnesium oxide, silica, iron oxide, aluminum oxide, and carbon dioxide. The sample shall be subjected to the following test methods: chemical analysis; fineness; normal consistency; time of setting; autoclave expansion; and compressive strength.
Scope
1.1 This specification covers hydrated hydraulic lime for structural purposes.
1.2 Hydrated hydraulic lime may be used in the scratch or brown coat of plaster, stucco, mortar, or in portland-cement concrete either as blend, amendment, or admixture.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 The following precautionary caveat pertains only to the test method portion, Section 11 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.