There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
Standard
Withdrawn, No replacement
Last Updated: Mar 06, 2018
Track Document
ASTM C115/C115M-10e1
Standard Test Method for Fineness of Portland Cement by the Turbidimeter (Withdrawn 2018)
Standard Test Method for Fineness of Portland Cement by the Turbidimeter (Withdrawn 2018)
C0115_C0115M-10E01
ASTM|C0115_C0115M-10E01|en-US
Standard Test Method for Fineness of Portland Cement by the Turbidimeter (Withdrawn 2018)
Standard
C115/C115M Standard Test Method for Fineness of Portland Cement by the Turbidimeter (Withdrawn 2018)>
new
BOS Vol. 04.01 Committee C01
$
0.00
Out of stock
Significance and Use
3.1 The purpose of this test method is to determine whether or not the hydraulic cement under test meets the Wagner turbidimetric fineness requirements of the applicable hydraulic cement specification for which the test is being made. Fineness of the cement component is only one of the many characteristics that influence the strength capabilities of concrete.
Scope
1.1 This test method covers determination of the fineness of portland cement as represented by a calculated measure of specific surface, expressed as square centimetres of total surface area per gram, or square metres of total surface area per kilogram, of cement, using the Wagner turbidimeter.2
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Values in SI units [or inch-pound units] shall be obtained by measurement in SI units [or inch-pound units] or by appropriate conversion, using the Rules for Conversion and Rounding given in IEEE/ASTM SI 10 of measurements made in other units. Values are stated in SI units when inch-pound units are not used in practice.