Standard
Historical
Last Updated: Sep 20, 2022
Track Document
ASTM B988-18
Standard Specification for Powder Metallurgy (PM) Titanium and Titanium Alloy Structural Components
Standard Specification for Powder Metallurgy (PM) Titanium and Titanium Alloy Structural Components
B0988-18
ASTM|B0988-18|en-US
Standard Specification for Powder Metallurgy (PM) Titanium and Titanium Alloy Structural Components
Standard
B988 Standard Specification for Powder Metallurgy (PM) Titanium and Titanium Alloy Structural Components>
new
BOS Vol. 02.05 Committee B09
$
77.00
In stock
Abstract
This specification covers powder metallurgy (PM) structural components fabricated from commercially pure (CP) (that is, unalloyed) titanium powder, pre-alloyed powders, and mixtures of elemental powders or mixtures of elemental powders and pre-alloyed powders. It addresses ordering information, materials and manufacture, chemical composition requirements, tensile requirements, physical properties, mechanical properties, dimensions, mass, permissible variations, sampling, inspection, and certification.
Scope
1.1 This specification covers powder metallurgy (PM) structural components fabricated from:
1.1.1 Commercially pure (CP) (that is, unalloyed) titanium powder,
1.1.2 Pre-alloyed powders.
1.1.3 Mixtures of elemental powders or mixtures of elemental powders and pre-alloyed powders.
1.2 This specification covers:
1.2.1 Grade 1 PM—Unalloyed titanium,
1.2.2 Grade 2 PM—Unalloyed titanium,
1.2.3 Grade 3 PM—Unalloyed titanium,
1.2.4 Grade 4 PM—Unalloyed titanium,
1.2.5 Grade 5 PM—Titanium alloy (6 % aluminum, 4 % vanadium),
1.2.6 Grade 9 PM—Titanium alloy (3 % aluminum, 2.5 % vanadium),
1.2.7 Ti-6Al-4V PM Low Interstitial (LI),
1.2.8 Ti-6Al-6V-2Sn PM.
1.3 The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.