Standard
Historical
Last Updated: Dec 31, 2010
Track Document
ASTM B923-02
Standard Test Method for Metal Powder Skeletal Density by Helium or Nitrogen Pycnometry
Standard Test Method for Metal Powder Skeletal Density by Helium or Nitrogen Pycnometry
B0923-02
ASTM|B0923-02|en-US
Standard Test Method for Metal Powder Skeletal Density by Helium or Nitrogen Pycnometry
Standard
B923 Standard Test Method for Metal Powder Skeletal Density by Helium or Nitrogen Pycnometry>
new
BOS Vol. 02.05 Committee B09
$
77.00
In stock
Significance and Use
Both suppliers and users of metals can benefit from knowledge of the skeletal density of these materials. Results of many intermediate and final processing steps are controlled by or related to skeletal density of the metal. In addition, the performance of many sintered or cast metal structures may be predicted from the skeletal density of the starting metal powder, for all or a portion of the finished piece.
Scope
1.1 This test method covers determination of skeletal density of metal powders. The test method specifies general procedures that are applicable to many commercial pycnometry instruments. The method provides specific sample outgassing procedures for listed materials. It includes additional general outgassing instructions for other metals. The ideal gas law forms the basis for all calculations.
1.2 This test method does not include all existing procedures appropriate for outgassing metal materials. The included procedures provided acceptable results for samples analyzed during an interlaboratory study. The investigator shall determine the appropriateness of listed procedures.
1.3 This method uses SI units as standard according to Practice E 380. State all numerical values in terms of SI units unless specific instrumentation software reports volume and/or density using alternate units. In this case, present both reported and equivalent SI units in the final written report. Many instruments report skeletal density as g/cm3 instead of using correct SI units (kg/m 3).
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.