Standard
Historical
Last Updated: Oct 20, 2016
Track Document
ASTM B824-14
Standard Specification for General Requirements for Copper Alloy Castings
Standard Specification for General Requirements for Copper Alloy Castings
B0824-14
ASTM|B0824-14|en-US
Standard Specification for General Requirements for Copper Alloy Castings
Standard
B824 Standard Specification for General Requirements for Copper Alloy Castings>
new
BOS Vol. 02.01 Committee B05
$
86.00
In stock
Significance and Use
14.1 For the purpose of determining compliance with the specified limits for requirements of the properties listed in the following table, an observed value or a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29.
| Property | Rounded Limit for Observed or |
|
| |
| Chemical Composition | nearest unit in the last right-hand significance digit used in expressing the limiting value |
|
|
|
| Tensile Strength | nearest ksi (5 MPa) |
| Yield Strength | |
|
|
|
| Elongation | nearest 1 % |
|
|
|
| Grain Size: |
|
| Under 0.060 mm | nearest multiple of 0.005 mm |
| 0.060 mm and over | nearest 0.01 mm |
Abstract
This specification establishes the general requirements common to copper alloy castings of UNS Nos. C94700, C95300, C95400, C95410, C95500, C95520, and C96800. Materials shall be sampled and prepared, then tested accordingly to examine their conformance to mechanical (tensile and yield strength, hardness, and elongation), electrical (resistivity and conductivity), dimensional, chemical composition, and grain size requirements. In the event of conflict between this specification and the individual casting product specifications, the requirements of the casting specification shall take precedence.
Scope
1.1 This specification establishes general requirements common to ASTM copper alloy casting specifications B22, B61, B62, B66, B67, B148, B176, B271/B271M, B369, B427, B505/B505M, B584, B763/B763M, B770, and B806. These requirements apply to the casting specifications to the extent referenced therein.
1.1.1 In the event of conflict between this specification and a casting specification, the requirements of the casting specification shall take precedence.
1.2 The chemical composition and other requirements not included in this specification shall be prescribed in the casting product specifications.
1.3 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 No precise quantitative relationship can be stated between the properties of the metal in various locations of the same casting or between the properties of castings and those of a test bar casting from the same metal. (See Appendix X1.)2