Standard
Active
Last Updated: Nov 07, 2023
Track Document
ASTM B555-86(2023)
Standard Guide for Measurement of Electrodeposited Metallic Coating Thicknesses by Dropping Test
Standard Guide for Measurement of Electrodeposited Metallic Coating Thicknesses by Dropping Test
B0555-86R23
ASTM|B0555-86R23|en-US
Standard Guide for Measurement of Electrodeposited Metallic Coating Thicknesses by Dropping Test
Standard
B555 Standard Guide for Measurement of Electrodeposited Metallic Coating Thicknesses by Dropping Test>
new
BOS Vol. 02.05 Committee B08
$
72.00
In stock
ASTM International
Significance and Use
4.1 The thickness of a metal coating is often critical to its performance.
4.2 This procedure is useful for an approximate determination when the best possible accuracy is not required. For more reliable determinations, the following methods are available: Test Methods B487, B499, B504, and B568.
4.3 This test assumes that the rate of dissolution of the coating by the corrosive reagent under the specified conditions is always the same.
Scope
1.1 This guide covers the use of the dropping test to measure the thickness of electrodeposited zinc, cadmium, copper, and tin coatings.
Note 1: Under most circumstances this method of measuring coating thicknesses is not as reliable or as convenient to use as an appropriate coating thickness gauge (see Test Methods B499, B504, and B568).
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.