Standard
Active
Last Updated: Jan 27, 2026
Track Document
ASTM B169/B169M-26
Standard Specification for Aluminum Bronze Sheet, Strip, and Rolled Bar
Standard Specification for Aluminum Bronze Sheet, Strip, and Rolled Bar
B0169_B0169M-26
ASTM|B0169_B0169M-26|en-US
Standard Specification for Aluminum Bronze Sheet, Strip, and Rolled Bar
Standard
B169/B169M Standard Specification for Aluminum Bronze Sheet, Strip, and Rolled Bar>
new
BOS Vol. 02.01 Committee B05
$
64.00
In stock
ASTM International
Abstract
This specification establishes the requirements for UNS C61300 and C61400 copper aluminum bronze alloy sheets, strips, and rolled bars. These products are intended for drawing, forming, stamping, and bending applications but not for electrical applications. Each product is hot or cold rolled to finish gage and then annealed, if required, to meet the required temper properties. This specification also contains information on the required tensile strength, yield strength at extension under load, and elongation for different temper designations and product dimensions.
Scope
1.1 This specification2 establishes the requirements for copper alloy UNS Nos. C61300 and C61400 aluminum bronze sheet, strip, and rolled bar.
1.2 The products made to this specification are commonly used for drawing, forming, stamping, and bending applications and are not intended for electrical applications.
Note 1: The products produced under this general specification may be used in many applications in which the individual requirements may be too specific to be determined by normal physical or mechanical testing. Therefore, it may be advisable for the purchaser to submit samples or drawings to the manufacturer to be assured that the product furnished is suitable for the intended application.
Note 2: Refer to Specification B171/B171M for plate product.
1.3 Units—The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.4 The following safety hazard caveat pertains only to the test method(s) described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.