Standard
Historical
Last Updated: Nov 17, 2011
Track Document
ASTM B121/B121M-01(2006)
Standard Specification for Leaded Brass Plate, Sheet, Strip, and Rolled Bar
Standard Specification for Leaded Brass Plate, Sheet, Strip, and Rolled Bar
B0121_B0121M-01R06
ASTM|B0121_B0121M-01R06|en-US
Standard Specification for Leaded Brass Plate, Sheet, Strip, and Rolled Bar
Standard
B121/B121M Standard Specification for Leaded Brass Plate, Sheet, Strip, and Rolled Bar>
new
BOS Vol. 02.01 Committee B05
$
77.00
In stock
Abstract
This specification establishes the requirements leaded brass plates, sheets, strips, and rolled bars made from UNS C33500, C34000, C34200, C34000, C35000, C35300, or C35600 copper-zinc-lead alloys. Each product should be manufactured by hot or cold working, and annealed if required, to produce a uniform wrought structure that meets the specified temper properties. This specification also contains information on the standard tempers of rolled and annealed materials as well as the required tensile strength, Rockwell hardness, and grain sizes. The Rockwell hardness test can be used to test for general conformity to the specification requirements for temper, tensile strength and grain size.
Scope
1.1 This specification establishes the requirements for copper-zinc-lead alloys (leaded brass) plate, sheet, strip, and rolled bar. The following alloys are covered:
1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.