Standard
Historical
Last Updated: Mar 18, 2020
Track Document
ASTM A939/A939M-15
Standard Practice for Ultrasonic Examination from Bored Surfaces of Cylindrical Forgings
Standard Practice for Ultrasonic Examination from Bored Surfaces of Cylindrical Forgings
A0939_A0939M-15
ASTM|A0939_A0939M-15|en-US
Standard Practice for Ultrasonic Examination from Bored Surfaces of Cylindrical Forgings
Standard
A939/A939M Standard Practice for Ultrasonic Examination from Bored Surfaces of Cylindrical Forgings>
new
BOS Vol. 01.05 Committee A01
$
77.00
In stock
Significance and Use
3.1 This practice shall be used when ultrasonic inspection from the bore surface is required by the order or specification for inspection purposes in which the acceptance of the forging is based on limitations of the number, amplitude, or location of discontinuities or a combination thereof, which leads to ultrasonic indications.
3.2 The acceptance criteria shall be stated clearly as order requirements.
3.3 This practice requires pitch-catch search unit with twin transducers, which depending on the angle, are sensitive only to 2 to 3 in. [50 to 75 mm] into the metal from the bore surface.
Scope
1.1 This practice covers a basic procedure of ultrasonically inspecting cylindrical forgings with bores from the bore surface.
1.2 This practice applies to the manual testing mode. It does not restrict the use of other testing modes, such as mechanized or automated.
1.3 This practice applies to cylindrical forgings having bore sizes equal to or greater than 2.5 in. [64 mm].
1.4 This practice is expressed in inch-pound and SI units; however, the inch-pound units shall apply unless the purchase order or contract specifies the applicable “M” specification designation (SI units). The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.