Standard
Active
Last Updated: Mar 22, 2024
Track Document
ASTM A886/A886M-24
Standard Specification for Low-Relaxation, Indented, Seven-Wire Steel Strand for Prestressed Concrete
Standard Specification for Low-Relaxation, Indented, Seven-Wire Steel Strand for Prestressed Concrete
A0886_A0886M-24
ASTM|A0886_A0886M-24|en-US
Standard Specification for Low-Relaxation, Indented, Seven-Wire Steel Strand for Prestressed Concrete
Standard
A886/A886M Standard Specification for Low-Relaxation, Indented, Seven-Wire Steel Strand for Prestressed Concrete>
new
BOS Vol. 01.04 Committee A01
$
64.00
In stock
ASTM International
Abstract
This specification covers seven-wire uncoated, indented, stress-relieved carbon steel strands for use in pre-stressed concrete construction. Wire dimensions, indentations, and mechanical properties shall be in accordance to the values specified in this specification. The carbon steel strand is produced to satisfy only the specified mechanical properties, this specification contains no information on the chemical composition of the wires.
Scope
1.1 This specification covers low-relaxation, indented, Grade 270I [1860I] seven-wire steel strand for use in prestressed concrete construction. Grade 270I [1860I] has a minimum tensile strength of 270 ksi [1860 MPa] based on the nominal area of the strand.
1.2 The text of this specification references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables) shall not be considered as requirements of the specification.
1.3 This specification is applicable for orders in either inch-pound units (as Specification A886) or in SI units (as Specification A886M).
1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the specification.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.