Standard
Historical
Last Updated: Jul 08, 2013
Track Document
ASTM A705/A705M-95(2009)
Standard Specification for Age-Hardening Stainless Steel Forgings
Standard Specification for Age-Hardening Stainless Steel Forgings
A0705_A0705M-95R09
ASTM|A0705_A0705M-95R09|en-US
Standard Specification for Age-Hardening Stainless Steel Forgings
Standard
A705/A705M Standard Specification for Age-Hardening Stainless Steel Forgings>
new
BOS Vol. 01.03 Committee A01
$
86.00
In stock
Abstract
This specification covers age-hardening stainless steel forgings for general use. Materials for forgings shall consist of billets or bars and shall either be forged, rolled, or cast or a section cut from an ingot. The steel specimens shall be solution annealed and age hardened and shall conform to the required values of tensile strength, yield strength, elongation, reduction of area, hardness and impact Charpy-V. The steel materials shall conform to the required chemical compositions of carbon, manganese, phosphorus, sulfur, silicon, chromium, nickel, aluminum, molybdenum, titanium, copper, nitrogen, columbium, and tantalum.
Scope
1.1 This specification covers age-hardening stainless steel forgings for general use.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 Unless the order specifies an “M” designation, the material shall be furnished to inch-pound units.
Note 1—Bar products are covered by Specification A 564/A 564M