Standard
Historical
Last Updated: Nov 14, 2014
Track Document
ASTM A641/A641M-09a
Standard Specification for Zinc-Coated (Galvanized) Carbon Steel Wire
Standard Specification for Zinc-Coated (Galvanized) Carbon Steel Wire
A0641_A0641M-09A
ASTM|A0641_A0641M-09A|en-US
Standard Specification for Zinc-Coated (Galvanized) Carbon Steel Wire
Standard
A641/A641M Standard Specification for Zinc-Coated (Galvanized) Carbon Steel Wire>
new
BOS Vol. 01.06 Committee A05
$
86.00
In stock
Abstract
This specification covers the soft, medium, and hard temper zinc-coated (galvanized) carbon steel wire in coils for general use. The steel shall be made by any commercially accepted steel making process. The material shall conform to the tensile strength requirements specified. The zinc-coated wire shall conform to the requirements for minimum weight of zinc coating of the specified class. Zinc-coated wire produced as regular coating shall have the full surface covered with zinc, but there is no specified minimum weight of coating. Adhesion tests shall be done.
Scope
1.1 This specification covers soft, medium, and hard temper zinc-coated (galvanized) carbon steel wire in coils for general use.
1.2 The supplementary requirements of this specification cover zinc-coated weights [masses] for nails, staples, and wire from which nails and staples are cut and formed.
1.3 This specification is applicable to orders in either inch-pound units (as A 641) or SI units (as A 641M). Values stated in either inch-pound units or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in the two systems are not exact equivalents; therefore, each system shall be used independent of the other, without combining values in any way.
1.4 This specification and some referenced specifications are expressed in both inch-pound and SI units. If the order specifies the applicable “M” specification designation, the product shall be furnished to SI units.
1.5 The text of this specification references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.