Standard
Historical
Last Updated: Feb 09, 2022
Track Document
ASTM A574-17
Standard Specification for Alloy Steel Socket-Head Cap Screws
Standard Specification for Alloy Steel Socket-Head Cap Screws
A0574-17
ASTM|A0574-17|en-US
Standard Specification for Alloy Steel Socket-Head Cap Screws
Standard
A574 Standard Specification for Alloy Steel Socket-Head Cap Screws>
new
BOS Vol. 01.09 Committee F16
$
86.00
In stock
Abstract
This specification covers the requirements for quenched and tempered alloy steel socket-head cap screws. The screws shall be fabricated from steel made to fine grain practice and shall be alloy steel conforming to the chemical composition specified. Different tests shall be conducted in order to determine the following mechanical properties of screws: tensile or wedge strength, proof load, yield strength, elongation, Rockwell hardness, and Vickers hardness.
Scope
1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket-head cap screws, 0.060 through 4 in. in diameter where high strength is required.
1.2 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 The following hazard caveat pertains only to the test method portions, sections 5.1, 5.6, 8, and 12, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.