Standard
Historical
Last Updated: Mar 04, 2015
Track Document
ASTM A470/A470M-05(2010)
Standard Specification for Vacuum-Treated Carbon and Alloy Steel Forgings for Turbine Rotors and Shafts
Standard Specification for Vacuum-Treated Carbon and Alloy Steel Forgings for Turbine Rotors and Shafts
A0470_A0470M-05R10
ASTM|A0470_A0470M-05R10|en-US
Standard Specification for Vacuum-Treated Carbon and Alloy Steel Forgings for Turbine Rotors and Shafts
Standard
A470/A470M Standard Specification for Vacuum-Treated Carbon and Alloy Steel Forgings for Turbine Rotors and Shafts>
new
BOS Vol. 01.05 Committee A01
$
86.00
In stock
Abstract
This specification covers vacuum-treated carbon and alloy steel forgings for turbine rotors and shafts. Materials shall be manufactured and treated by: melting process via basic electric-furnace; secondary melting process via electrode-electroslag or vacuum-arc remelting; vacuum degassing; forging process via hot mechanical working; heat treatment via double-normalizing and tempering, or normalizing, quenching and tempering; and rough machining and axial boring. Tension and impact tests shall be done to evaluate the conformance of steel forgings with the following mechanical properties: tensile strength and toughness, notch toughness, yield strength, elongation, and reduction of area. Chemical composition conformances shall also be assessed by heat and product analyses. Nondestructive tests, such as ultrasonic and internal examination, and stability tests shall also be performed. Retreatments may be executed one or more times, but not more than three additional times, if results of the mechanical tests do not conform to specified requirements.
Scope
1.1 This specification covers vacuum-treated carbon and alloy steel forgings for turbine rotors and shafts.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.