Standard
Active
Last Updated: May 28, 2025
Track Document
ASTM A65-25
Standard Specification for Steel Track Spikes
Standard Specification for Steel Track Spikes
A0065-25
ASTM|A0065-25|en-US
Standard Specification for Steel Track Spikes
Standard
A65 Standard Specification for Steel Track Spikes>
new
BOS Vol. 01.04 Committee A01
$
64.00
In stock
ASTM International
Abstract
This specification covers steel track spike to be used as fastenings between railroad rails, tie plates, and ties. Several tests shall be conducted, namely: heat or cast analysis; alternative analysis; alternative tension test; product analysis; body bend test; and head bend test. Heat and product analysis shall be performed wherein steel materials shall conform to the required chemical composition for carbon, manganese, phosphorous, sulfur, silicon, and copper. Steel specimens shall also undergo tensile tests and conform to required values of yield point, tensile strength, and elongation.
Scope
1.1 This specification covers steel track spikes used as fastenings between railroad rails, tie plates, and ties.
1.2 Three grades of spikes are described, Grades 1, a lower carbon steel; Grade 2, a higher carbon steel; and Grade 3, a carbon structural steel, conforming to Specification A36/A36M.
1.3 Supplementary Requirement (S1) are provided for use and shall only apply when specified in the purchase order.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.